pp0736a295.jpg
pp8ea414ef.png
pp44cab40b.jpg
home_body4_13.jpg
pp25b7032a.png
pp386d481d.png
ppadb95f45.png
1621 Victor Rd.
Lancaster, OH  43130
(740) 687-4770
pp62c97895.png
ppc4f6f532.jpg
pp517ddd4e.png
pp90f6157b.png
pp45f67a5f.png
COPYRIGHT © 2008 RAINBOWPOOLS.NET ALL RIGHTS RESERVED
Our site is under construction. Not all links are currently working. Sorry for any inconvenience.
pp8c4a28dc.png
OPENING GUIDE
Take a sample of your pool water to your Authorized Sustain System Dealer.
Balance the water in your pool by following your dealers recommendations based on your test results.
When opening your pool, add Stabilizer to achieve a level of 80 ppm.
·
Add stabilizer after the pool has been cleaned and the filter has been backwashed.
·
Add the stabilizer slowly into the skimmer in small increments with the pump running.
·
Run the pump continuously for at least 4 days.
Establish a Free Available Chlorine (FAC) residual to eliminate the remaining invisible contaminants in the water. FAC is the active form of chlorine that should be maintained in the ideal range of 1-3 ppm to be assured the water is sanitized. When opening your pool, add two pounds of Shock Treatment, according to label directions, for every 10,000 gallons of water (twice the normal dose). Operate your pool's pump for 24 hours and test for FAC. If the reading is less than 1 ppm after 24 hours, continue shocking the pool (2 lbs./10,000 gallons) until 1 ppm of FAC is established when you test the following day.

If FAC is 1 ppm or greater, your’e ready to begin using the Sustain 3-part System. Now its time to add the Sustain® System products.
·
Step One: Add Sustain Summer Shield® Chlorine Extender. Simply pour the Shield Extender into the skimmer or into the water around the sides of the pool.
·
Step Two: Fill the skimmer dispenser with blue Sustain® 3-Inch Chlorinating Tablets and place the dispenser in the skimmer basket, open end up. (Never mix blue Sustain® Tablets with white chlorinating tablets.) The skimmer dispenser comes with an adjustable lid to regulate chlorine delivery. Adjust the lid opening to increase or decrease chlorine delivery to maintain 1-3 ppm FAC. For in-ground pools, start with the lid off, and use it later, if necessary. For above-ground pools, start with the lid fully open and adjust as needed.
·
Step Three: Add Sustain® Shield Energizer Tablets to the skimmer basket, (one cup for every 5,000 gallons of water). Continue to circulate the water for at least 5 hours.


WEEKLY MAINTENANCE GUIDE
ü
Fill the 3” Chlorinating Tablet dispenser and place it in the skimmer basket, open end up. Refill dispenser once per week or as needed to maintain an 1-3 ppm Chlorine Level.
ü
Add 1 cup of Energizer Tablets for every 5000 gallons of pool water.
ü
Test pool water with Chlorine test strips weekly.
ü
If there are any problems, we ask our customers to bring in a water sample. We need approximately 1 cup of pool water to perform a computerized water analysis.


CLOSING GUIDE
Follow our instructions to adjust Total Alkalinity and other water balance factors during pool closing. You should have 1-3 ppm FAC before proceeding to Step #2. Keep the pump running continuously for thorough mixing of chemicals until Step 3 is completed.
Pour in Sustain Winter Shield™ Chlorine Extender, using 32 fluid ounces for every 20,000 gallons of water. (Add only six fluid ounces if the pool has less than 7,500 gallons.
"Superchlorinate" your pool, using a double dose of Sustain Shock Treatment (2 pounds for every 10,000 Gallons). Be sure to follow label directions to avoid bleaching of vinyl liners.
Clean your pool, filter and all other mechanical equipment thoroughly.
Partially drain your pool. Check with us to determine proper water levels and procedures for your climate.
Cover your pool with a winter pool cover.
pp1ecd8b34.png